There are specific requirements from Juniper for this (available here), make sure that you follow the requeirements for your use case. Set the appropriate amount of vCPU's for the forwarding plane.Set the appropriate amount of RAM for the control plane.For my case, 3 vCPU's is more than enough. Set the appropriate number of vCPU's for the control plane.This management interface is where the control plane and forwarding plane interfaces will be bound to to make the initial setup and troubleshooting more convenient. Set the appropriate host-management-interface.Update the routing-engine-image, routing-engine-hdd and forwarding-engine-image paths under HOST: to be the correct file locations - the RE engine image and vFPC image names may be different as well if you are using a release other than 18.1R1.You will need to change a few values from the sample configuration file I have provided: Edit vmx.conf in your favourite editor. Remove the default configuration file, its easier to copy the entire config from here and adjust as needed:.The Juniper vMX document from Juniper available here contains some sample configurations. The configuration file is in YAML format and defines what interfaces on the host to bind to the vMX and what resources the vMX will have. The Juniper vMX configuration file needs to be created.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |